Specifications

22
Figure 29: Slider/Damper Adjustment
TURNING YOUR PELLET STOVE OFF:
To turn off your Pellet stove just press the Power button. This will not shut off the stove instantly, it will
take approximately 5 minutes for the fire to burn out. The fans will stay running until the unit has cooled
sufficiently.
NEVER unplug a unit that is running!
DO NOT unplug unit while Combustion fan is running.
Unplugging may cause smoke to be released into the home.
DAMPER SET-UP:
DAMPER MUST BE SET AT TIME OF INSTALLATION. This is used to regulate the airflow through
the pellet stove, this is key to an efficient clean burn. See figure 29.
If the pellets being burnt are of poor quality there is a higher chance of clinker build up and over time
the fire may build up and overflow the burn pot. Poor quality pellets will require more primary air to help
OPERATION YOUR PELLET STOVE:
PRE-BURN INSTRUCTIONS: The burn pot liner holes must be clear and the liner installed properly
against the ignitor tube for proper operation. Check the hopper for enough pellets to start the unit.
DO NOT OPERATE THE UNIT WITH THE DOOR OR ASH PAN OPEN.
TO START: Press the Power button. The stove will turn on. The LED beside the Power button will flash
to indicate a start-up cycle. The Heat Level is shown on the LED display, you can change the Heat Level
and mode but these adjustments will not take affect until the start-up cycle is complete. If this is the first
time the unit has been started or the unit has run out of fuel, the auger will need to be primed. You may
need restart the unit if an E3 error occurs, to do this just press the Power button again. Once you see
pellets start to drop the auger is primed.
TO OPERATE: When a fire has been established, the Power LED will turn solid (after approximately 10
- 15 minutes) the current settings will now take affect.
The convection blower (room air blower) will turn on. The speed of this blower is automatically controlled
and is based off the heat level setting.
Operating Instructions
Damper
complete the burn, the slider damper must be pulled
out to compensate. Pulling the slider damper out gives
the fire more air. It is crutial to make sure the burn
pot is clean and that no holes are blocked for proper
combustion. It is recommended to get the stove hot
then set the damper at heat level 1, this is the most
sensitive setting.
There are two ways to set the damper. You can visually
set the damper if you have experience.
• A tall, lazy flame with dark orange tips requires more
air – Open slider (pull out) slightly.
• A short, brisk flame, like a blowtorch, has too much
air – Close slider (push in) slightly.
• If the flame is in the middle of these two characteristics
with a bright yellow/orange, active flame with no
black tips then the air is set for proper operation,
refer to Figure 30.