- Sherwood Industries Ltd. Stove User's Manual

PARTS AND ACCESSORIES

Service Parts available from your local Envirogas Dealer

Burner Control Assembly

Natural Gas Pilot Assembly

Propane Pilot Assembly

Door Bolt

Relief Door Gasket

Regulating Valve

Piezo Igniter

Burner Switch

B-vent Spill switch 220°

Orifice Blank

Convection Blower

Light Bulb Holder

Light Switch (momentary)

Fan Controller

Log Set (with Embers)

Thermocouple

Embers

Thermopile

Door Gasket

Convection Fan Sensor 120 F (49C)

Accessories

Gold trim Package

Low Voltage Thermostat

REMOVING or LUBRICATING THE BLOWER

The blower should be lubricated every 12 mos.

1. Turn the unit off and remove the log set.

2. Remove the burner tray assembly by

removing the screw on either side of the

tray, between the front and rear burners.

Lift the tray out. Remove the brick liner by

undoing the screw on either side and

sliding the panel out.

3. Remove the 4-5/16” bolts that hold the

blower mounting plate to the back firewall.

Use a light lubricating oil on screws before

removal.

4. Carefully pull the blower assembly into the

firebox, exposing the blower lubricating

holes (located on the top of the motor

housing on either side of the label). Add 2

drops of SAE 20 oil.

5. If removal of the blower is necessary, disconnect the blower leads from the harness. Remove the blower.

6. To re-install, check mounting plate gasket and reverse steps 1 through 4.