Indoor Fireplace User Manual

Maintenance and Service

CLEANING PLATED SURFACES:

It is important to note that ngerprints and other marks can leave a permanent stain on plated nishes.

To avoid this, give the face a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the

replace. Never clean the face when it is not cool. Do not use other cleaners as they may leave a

residue, which can become permanently etched into the surface.

BLOWER REMOVAL:

The burner may need to be removed for a few reasons, including cleaning under the burner, converting

the unit to a different gas type, or to replace the burner altogether. Proceed only when the unit has

completely cooled down.

1. Remove the door as shown in the MAINTENANCE AND SERVICE - OPENING THE DOOR.

2. Remove the two (2) T-20 screws that fasten the lower half of the burner bracket to the burner tray,

located inside the large hole in the burner (see Figure 7). Do not remove the screws that fasten the

upper half of the burner bracket to the burner.

3. Slide the burner to the left then lift the burner assembly up then out.

BLOWER REMOVAL:

Figure 8: Blower (Fan) Removal.

To re-install the burner

follow steps 1-3 in reverse.

When placing the burner

back in the unit ensure that

the venturi box under the

burner is lined up.

1. Turn the unit off, allow it to cool down completely,

and remove the door as shown in the MAINTENANCE AND

SERVICE - OPENING THE DOOR..

2. Remove the log set carefully.

3. Remove the burner tray assembly, see MAINTENANCE AND

SERVICE - BURNER REMOVAL.

4. Remove the four (4)

/16” bolts that hold the blower

mounting plate to the back rewall. Use a light

lubricating oil on screws before removal.

5. Carefully pull the blower assembly into the rebox

(see Figure 8) disconnect the blower leads from the

harness and remove blower.

6. To re-install, check mounting plate gasket if damaged

replace with new one and reverse steps 1 through 4.

Refer to “SECONDARY INSTALLATION - LOG SET AND EMBERS

INSTALLATION”.

Burner Bracket

Figure 7: Blower (Fan) Removal.