Owner`s manual

Exhaust Tube
3" (75mm) or 4" (100mm)
"PL" or "L" vent
Wall Thimble
45° Elbow with screen
or Termination Cap
Fresh Air Intake
High Temperature RTV
Silicone Required
13
• This is due to the back pressure in the exhaust
caused by airflow around the structure.
• All sections of pipe must have three (3)
screws evenly spaced and all horizontal
and vertical vent sections located within the
house must have a bead of high temperature
silicone installed on the male end of the pipe
before installation to create a gas tight seal.
• The termination must be 12 inches (30 cm)
from the outside wall and 12 inches (30 cm)
above the ground.
• A 45° elbow with a rodent screen may be
used in place of the termination cap (or
stainless steel termination hood).

Figure 13: Straight through wall Installation.
10. The pipe must
extend at least
12” (30 cm) away
from the building.
If necessary, bring
another length of
pipe (PL type) to the
outside of the home
to connect to the
first section. Do not
forget to place high
temperature silicone
around the pipe that
passes through the
thimble.
11. Install a vertical pipe,
or if all requirements
for direct venting
are met, install vent
termination. The
stainless steel cap
termination manufactured by the vent manufacturer is recommended. However, when the vent
terminates several feet above ground level and there are no trees, plants, etc. within several feet,
a 45° elbow can be used as termination. The elbow must be turned down to prevent rain from
entering.
NOTE:
• Some horizontal through wall installations may require a “T” and 3 to 5 feet (91 to 152 cm) of vertical
pipe outside the building to help naturally draft in the unit.
• This may be required if a proper burn cannot be maintained, after the stove has been tested and the
airflow set.
Figure 14: Straight through Wall Installation - Side View.
Wall framing
Wall thimble
Termination
cap
Vent pipe
Horizontal frame
for thimble