Owner`s manual

inStaLLation of inSeRt SuRRounD PaneL - fiRePLace inSeRt:

inStaLLation of contRoL PaneL in the SuRRounD PaneL - fiRePLace inSeRt:
20
A
Figure 24: Attaching the Control Panel
Tools Required: Torx T-20 Screwdriver
1. Remove the control panel from the shipping position on the unit by
removing one 8-32 x 3/8” Torx screw.
2. Align the control panel with the two holes in the surround panel and
fasten using two (2) 8-32 x 3/8” Torx screws.
B
Figure 23: Removing the control panel from the unit
Tools Required: None
1. Attach the control panel to the surround panel (see “Installation of
Control Panel in the Surround Panel - Fireplace Insert”)
2. Slip the surround panel down behind the unit as shown in Figure 32.
3. Hook the keyholes on the surround panel on the standoffs located on
the side panels of the unit.
4. Connect the control panel to the wiring harness.
The power cord can be routed to either side of the unit, the surround
panel has a knock-out on each side to allow for passage of the power
cord.
The surround panel must be removed to perform maintenance on the
internal components of the unit. Reverse the above steps to remove the
surround panel.
Figure 25: Attaching the Surround Panel