Owner`s manual
10
Maintenance And Service
REMOVING BURNER CONTROLS:
Move the rod located behind the
piezo ignitor to increase or decrease
primary air at the venturi tube.
Gas and electrical
tray complete
Air deflector
Burner top
1. Shut off gas supply to appliance.
2. Remove surround panels by pulling up, then out. Disconnect gas line from the valve. Disconnect harness at
connector on side of unit.
3. Open the door and remove the log. Remove the burner tray assembly by removing the TWO screws in the center
of the burner. Slide tray to the left, lift tray out.
4. Remove right and left side brick panel as per instructions. Undo the three screws that hold the air deector to
the rear of rebox. Undo the remaining screws that hold the burner controls in the rebox.
5. Install in the reverse order.
There is only one venturi and one air shutter to be
adjusted.
When installing the burner top, ensure that the venturi
tube is engaged to the air shutter adjustment rod.
Use this small venturi adjustment rod to achieve a proper
and efcient ame.
Caution: Bleed lines before lighting and
light pilot with door open
ADJUSTING VENTURI AIR SETTINGS:
When a plated surround or face is received, it should be unpacked/unwrapped carefully to avoid getting anything
on the surface of the nish, including cleaners, polish and nger prints. If your ngers come into contact with the
nishes, the oils left as ngerprints on the plating can become permanently etched in the surface. To prevent this,
clean all nishes with denatured alcohol after the installation and prior to rst ring of the replace.
If your ngers come into contact with the antique copper nish, the oils left as ngerprints on the copper can cause
discoloration, which will eventually turn green in that area. You can clean the patina or discolored areas of the
antique copper nish with “OO” 3M green sanding pads. These can be purchased from most hardware stores. On
the areas with discoloration, use the sanding pads to sand in the same direction as the brushed nish, then blend
the nish by feathering in the surrounding area. This renishing procedure has been approved by the manufacturer
and will not harm the nish. Please note: ANTIQUE COPPER IS THE ONLY FINISH THAT CAN BE SANDED, DO NOT
SAND PEWTER, GOLD OR NICKEL FINISHES.
MAINTAINING FACE AND SURROUND FINISHES: