Owner`s manual

11
Initial Installation
QUALIFIED INSTALLERS ONLY
Remove the vent collar plate from the top of the insert and connect it securely with sheet metal screws and/or hose
clamps. Check for any tears in the liner at this point. (See also Initial Installation Instructions.)
IMPORTANT: The screws that hold the vent collar plate in its’ approved position must be installed.
    
     
   
    
      
      
 
     
    
     
     
    
      
    

      
     
 
      
       
   
 
 
The ENVIRO FOCUS may be installed and vented into any solid fuel replace that has been installed in accordance
with the National, Provincial/State and local building codes and has been constructed of non-combustible
materials.
An approved chimney liner and rain cap must be used. A throat connector or ashing must be installed to ensure a
tight seal, top performance, safety and efciency. Carefully follow the manufacturer’s instructions which accompany
the chimney liner kit.
VENTING FIREPLACE INSERTS: