Owner`s manual

Initial Installation

QUALIFIED INSTALLERS ONLY

PREPARING YOUR FOCUS FOR INSTALLATION:

• Remove the packaging from the appliance and surround panels; check to make

sure there is no damage. Carefully check the glass door. Do not use the unit if it is

damaged. In the event damage is found, please report it to both the courier and your

dealer as soon as possible.

• Carefully clean the replace and ue before installing the stove. Failure to do so

may result in fumes or dirt being blown into the room and may cause a re leading

to death or serious injury.

1. Remove the unit from the box and remove all packaging material from the

appliance.

2. Open the door by removing the two 5/16’’ bolts located at the top outside corners

of the glass frame. Lift door up and remove from unit. CAUTION GLASS MAY

SEPARATE FROM DOOR.

8. Place one side and the top of the brass trim onto

the surround panel and use corner bracket to

secure pieces together. Place the second side of

brass trim on the surround panel and secure in the

same manner. Install spring clips provided behind

the brass trim to secure trim to the surround

panel.

9. Connect the wires from the unit to the ON/OFF/

THERMOSTAT switch and the FAN CONTROLLER

(see “Electrical Requirements” section).

10. Place the assembled surround panel around the

stove, align the slots. Push back then down to

engage the surround panel hooks with the slots

in the replace. Install the decorative fascia or bay

window options to the appliance by aligning the

hooks and the slots in the replace as seen in the

surround panel installation.

3. Remove log and ember set and all wrapping material from the stove. Remove

wrapping material from log and embers and check for any damage. If damage is

observed, do not use unit and contact your local dealer.

4. Remove the vent collar plate from the top of the stove by unscrewing the two T20

Torx screws located on the center top of the stove. Slide collar plate backwards.

Properly secure the vent collar plate to the exible vent pipe liner(s) previously

installed in the chimney. Be careful not to over-stretch the liner(s)

5. Install the leveling legs. (Thread the 5” (13 cm) bolt and locknut up into the

captive nut from the bottom).

6. Place the unit part way into the replace. Connect the replace insert’s exible

gas line to the household gas supply, using locally approved methods. Place the

electric cable so it can be connected to the power supply.

7. As you push the unit into its’ nal position in the replace, reinstall the vent collar

plate to the stove by sliding it along the draft hood and secure with the screw.

Adjust the leveling legs to ensure the unit is level.