Owner`s manual

Initial Installation

QUALIFIED INSTALLERS ONLY

ELECTRICAL REQUIREMENTS:

The Focus will operate without electrical power.

This model has a Millivolt gas control which uses

the pilot ame to generate enough electricity to

operate the main burners. This appliance when

equipped with a blower, must be electrically

connected and grounded in accordance with local

codes or in the absence of local codes, with the

current CSA C22.1 CANADIAN ELECTRICAL CODE

Part 1, SAFETY STANDARDS FOR ELECTRICAL

INSTALLATIONS, OR THE NATIONAL ELECTRICAL

CODE ANSI / NFPA 70 in the U.S.

WARNING: Electrical grounding instructions.

This appliance is equipped with a three-prong

(grounding) plug for your protection against shock

hazard, and should be plugged directly into a

properly grounded three-prong outlet. DO NOT cut

or remove the grounding prong from this plug.

CAUTION: Label all wires prior to disconnection

when servicing controls. Wiring errors can cause

improper and dangerous operation. Verify proper

operation after servicing.

INSTALLING THE BLOWER:

1. Turn the unit off, open the door and remove the log set. Remove the burner tray top by removing the two screws

located in the center of the burner tray. Slide tray to the left and lift out. Remove brick panels (see Removing

and Installing Brick Panels).

2. Remove the surround panel by lifting straight up and then pull out to free from the body of the unit. Turn gas

supply off and remove gas connection. Disconnect the wiring from the side of the appliance.

3. Remove the screws that hold the air deector located on the back rewall and undo the remaining screws that

hold the burner assembly in the appliance. Carefully remove the gas tray assembly from the rebox, ensuring

that no wires or gas lines are damaged.

4. Remove the blower and housing from the gas tray assembly by removing the fastening screws located on the

back of the gas tray assembly. Disconnect the wiring from the fan temperature sensor and remove.

5. Hook up wires from the new blower to main wiring harness and fan temperature sensor. Install the blower in the

reverse order as described in Step 4.

6. Reinstall the completed gas tray into the rebox, being careful not to damage any wires or gas lines. Properly

secure the gas tray assembly in the rebox. Hook up gas lines and wiring harness. Perform a gas leak check on

all gas line with a soap and water solution or an approved method.

7. Install surround panel. (Return unit to original location if moved). Re-install brick panels, burners, logset and

door.

8. Check burner and blower assembly for proper operation.