Owner`s manual
9
Maintenance And Service
ROUTINE MAINTENANCE:
At least once a year, run through the following procedures to ensure the system is clean and working properly.
Periodically check the burner and pilot. Check the burner to see if all the ports are clear and clean. Check the pilot
to make sure it is not blocked by anything. The pilot ame should be blue with little or no yellow on the tips.
OPENING THE DOOR:
Turn unit off and wait until the appliance has cooled down.
Remove the decorative fascia by lifting up and remove from the slots in the body of the unit.
If a clip-on bay window is installed, lift up and remove from the slots in the body of the unit.
Undo the two
5
/16’’ bolts at the top of the door frame and then lift the glass and frame, being careful that the glass
does not fall out of the door frame assembly. Install in the reverse order.
Ensure the door is properly fastened after cleaning before attempting to re-light the appliance.
CLEANING THE GLASS:
Do not clean glass when hot
It will be necessary to clean the ceramic glass periodically. During a cold start up, condensation will sometimes
form on the glass. This is a normal condition with all gas replaces and stoves. However, this condensation can
allow dust and lint to cling to the glass surface. Initial paint curing of the appliance can leave behind a slight lm
on the glass. This is a temporary problem. It is therefore recommended that the glass be cleaned initially after the
rst two weeks of use.
Depending upon the amount of use, cleaning should be required no more than two or three times per season.
To clean the door, use a mild glass cleaner and a soft cloth. Abrasive cleaners will damage the glass and
gold surfaces.
CLEANING THE FIREBOX:
Remove the log carefully from the rebox. Gently remove the embers and place on a piece of paper towel, until
ready to replace.
Vacuum the bottom of the rebox thoroughly. Carefully clean off any dust on the logs and brick panels and remove
any lint from the main burner and pilot burner.
After carefully replacing the log and embers in their correct positions, and the door has been resealed, re-light the
pilot, following the instructions on the attached label.
REPLACING DOOR GLASS:
The glass in this appliance is ceramic. If the glass is damaged or broken a factory replacement must be tted.
To Replace:
• Open door, remove the glass carefully.
• Install the new piece of glass with the large bulb in the gasket tape against the unit. Place the joint in the tape
in a bottom corner. Close door.
Glass must be purchased from an Enviro dealer. No substitute materials are allowed.
Warning: Clearances must be sufcient to allow access for maintenance and service
Warning: Failure to position the parts in accordance with this manual, or failure to use only parts specically
approved with this appliance may result in property damage or personal injury.