User manual

ManualsBrandsEnviro ManualsDomestic AppliancesIndoor Fireplace Haven Direct Vent Fireplace

Flue Pipe Adaptor

Wall Framing

Wall Thimble

Fire Stop

Exhaust 4" Flex Pipe

Combusion Air 6 5/8" Flex Pipe

Wire Spacers

9. Install the ex pipe assembly through the wall thimble, ensure that this portion of pipe slides through

the outside wall far enough to connect onto the vent termination cap.

10. Apply a bead of Mill-Pac Black sealant to the top section of the Ø4” (10 cm) by 5” (12.5 cm) ue collar

adaptor previously installed into the replace ue outlet. Slide the Ø4” (10 cm) ex vent over the ue

collar and secure with three (3) sheet metal screws evenly spaced.

11. Place a bead of high temperature

silicone on the intake collar of the

replace, slide the Ø6” (16.25

cm) ex intake liner over the collar,

secure the ex liner with three (3)

sheet metal screws evenly spaced.

12. On the outside of the exterior wall,

apply a bead of Mill-Pac Black

sealant to the Ø 4” (10 cm) pipe

of the vent terminal. Slide the ex

liner onto the vent terminal and

secure with three (3) sheet metal

screws evenly spaced.

13. Place a bead of high temperature

silicone on the intake collar of the

vent terminal, slide the Ø6” (16.25

cm) ex intake liner over the collar,

secure the ex liner with three (3)

sheet metal screws evenly spaced.

14. Attach the vent terminal to the

outside of the house using four (4)

wood screws provided.

15. Light the appliance and ensure

proper operation.

Figure 30: Installation of Fireplace Horizontal Vent Kit.

Initial Installation

QUALIFIED INSTALLERS ONLY

OTHER APPROVED VENT PARTS:

Table 4: Approved Vent Manufacturers

Manufacturer Trade Name Nominal Sizes

American Metal Products Ameri Vent Direct 4/6 and 5/8

Security Chimneys International LTD Secure Vent 4/6 and 5/8

Selkirk Metalbestos Direct-Temp 4/6

Simpson Dura Vent Direct Vent GS 4/6 and 5/8

The Haven replace has been tested and certied for use with AMERICAN METAL PRODUCTS “AMERIVENT

DIRECT”, SIMPSON DURAVENT TYPE GS PIPE FOR GAS STOVES. SECURITY CHIMNEY’S “SECURE VENT

DIRECT VENT SYSTEM” and SELKIRK “DIRECT-TEMP VENT SYSTEM” kits are available for horizontal and

vertical venting. When using Simpson Duravent, it is recommended that, before installation, a bead of

RTV High Temperature Silicone should be applied to each outer vent joint, and Mil-Pac to each inner

joint. When planning an installation, it will be necessary to select the proper length of vent pipe for the

particular requirements.