Specifications

2 ft

(61 cm)

Rain Cap (ensure cap

is at least 3ft (91cm)

above the roof at the

lowest point)

Roof Flashing

Roof Rafter

Fire Stop with

Support Collar

Ceiling Joist

Vertical Vent Pipe

Clean Out Tee with

Pipe Adapter

NOTE: All vent sections must

maintain 3 inches (7.6 cm)

clearances to combustibles.

Installation

inSide vertical inStallationS:

1. Place the unit on the hearth pad if a hearth pad is to be used (or on solid material if installed on a

carpeted surface) and space the unit in a manner so when the pellet vent is installed vertically, it will

be 3” (7.6 cm) away from a combustible wall.

2. Install the tee with clean out.

3. Install the pellet vent upward from there. When you reach the ceiling, make sure that the vent

goes through the ceiling fire stop. Maintain a 3” (7.6 cm) distance to combustibles and keep attic

insulation away from the vent pipe. Maintain an effective vapor barrier. Follow the Vent manufacturer’s

instructions.

4. Finally, extend the pellet vent to go through the roof flashing.

5. Ensure that the rain cap is approximately 24” (60 cm) above the roof.

6. Install the fresh air system.

Figure 16: Inside Vertical Installation.