Owner`s manual
3
Safety Precautions
FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” HEATER, 
PLEASE CAREFULLY READ THE FOLLOWING INFORMATION:
•  All  ENVIRO  gas-red  appliances  must  be  installed  in 
accordance with their instructions. Carefully read all the 
instructions in  this manual  rst. Consult the  building 
authority having jurisdiction to determine the need for a 
permit prior to commencing the installation.
• NOTE: Failure to follow these instructions could cause 
a malfunction of the replace, which could result in death, 
serious bodily injury, and/or property damage.
• Failure to follow these instructions may also void your 
re insurance and/or warranty.
GENERAL
•  Installation  and  repair  should  be  done  by  a  qualied 
service person. The appliance should be inspected before 
the rst use and, at least, annually by a qualied service 
person. More frequent cleaning may be required due to 
excessive lint from carpeting, bedding material, etc.   It 
is imperative the control compartments, burners and 
circulating air  passageways of  the appliance  be kept 
clean.
•  Due  to  high  temperatures,  the  appliance  should  be 
located out of high trafc areas and away from furniture 
and draperies.
Children  and  adults  should  be  alerted  to  the 
hazards of high surface temperatures and should 
stay away to avoid burn or clothing ignition.
•  Young  children  should  be  carefully  supervised  when 
in  the  same  room  as  the  appliance.    Toddlers,  young 
children  and others  may  be susceptible  to  accidental 
contact burns.  A physical barrier is recommended if there 
are at risk individuals in the house. To restrict access to a 
replace or stove install an adjustable safety gate to keep 
toddlers,  young  children  and  other at  risk  individuals 
out of the room and away from hot surfaces. Any safety 
screen or guard removed for servicing an appliance must 
be replaced prior to operating the appliance.
•  Clothing  or  other  ammable  materials  should  not  be 
placed on or near the appliance.
FOR YOUR SAFETY
• Installation and service must be performed by a qualied 
installer, service agency or gas supplier.
•  This  installation  must  conform  to  local  codes  or,  in  the 
absence  of  local  codes,  with  the  National  Fuel  Gas  Code, 
ANSI  Z223.1/NFPA  54,  or  the Natural  Gas and  Propane 
Installation Code, CSA B149.1.
• To prevent injury, do not allow anyone who is unfamiliar 
with the stove to operate it.
• To prevent injury, if the pilot or pilot and burners 
have gone out on their own, open the glass door and 
wait  5  minutes  to  air  out  before  attempting  to  re-
light the stove.
•  Always  keep  the  area  around  these  appliances  clear  of 
combustible material, gasoline and other ammable liquids 
and vapours.
• These appliances should not be used as a drying rack for 
clothing or for hanging Christmas stockings/decorations.
• Due to the paint curing on the stove, a faint odor and slight 
smoking will likely be noticed when the stove is rst used.  
Open a window until the smoking stops.
Always connect this gas stove to a vent system and vent to 
the outside of the building envelope. Never vent to another 
room  or  inside  the  building.  Make  sure  the  specied  vent 
pipe is  used, properly sized and  of adequate height  to 
provide sufcient draft.  Inspect the venting system annually 
for blockage and signs of deterioration.
WARNING: Failure to position the parts  in accordance 
with  the  diagrams  in  this  booklet,  or  failure  to  use  only 
parts specically approved with this appliance, may result in 
property damage or personal injury.
WARNING: Do not operate with the glass front removed, 
cracked or broken.  Replacement of the glass should be done 
by a licensed or qualied service person.
• Never use solid fuels such as wood, paper, cardboard, coal, 
or any ammable liquids, etc., in this appliance.
• Do not use this appliance if any part has been under water. 
Immediately call a qualied service technician to inspect the 
appliance and to replace any part of the control  system or 
any gas control which has been under water.
• Do not abuse the glass by striking it or slamming the door 
shut.
• If the Q2 unit is pulled out of its installation, and the vent-
air intake system is disconnected for any reason, ensure that 
the vent-air intake pipes are  reconnected and  re-sealed in 
accordance to the instructions noted in 
InItIal InstallatIon 
- DIrect Vent
HOT GLASS WILL 
CAUSE BURNS
DO NOT TOUCH 
GLASS UNTIL COOLED. 
NEVER ALLOW 
CHILDREN TO TOUCH 
GLASS. 
WARNING










