Instructions / Assembly

DRIVER REPLACEMENT

 This product is ENERGY STAR ® listed. The driver can be replaced without

having to cut wires. Please contact a qualified electrician if driver

replacement is needed.

FCC NOTICE

This device has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. However, there is no

guarantee that interference can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interface by one or more of the

following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the device and receiver.

 Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Problem

Solution

The light will not turn on.

 Make sure the power supply is on.

 Test or replace the switch.

 Check the wiring.

 Replace the driver.

The fuse blows or circuit breaker

trips when light is turned on.

 Check the wire connections.

TROUBLESHOOTING