Installation Guide

1. Plug the MALE CONNECTOR of the SOCKET ADAPTER to
the FEMALE CONNECTOR of top of the RETROFIT TRIM.
(FIG. 5)
3. If using TORSION SPRINGS, squeeze both TORSION
SPRING arms together and insert into the TORSION SPRING
SLOTS (or C-CLIPS) of the CAN. (FIG. 6A)
5. Tuck all wires into the CAN and carefully push the RETROFIT
TRIM into CAN. (NOTE: To provide enough room in shallow
cans, carefully position SOCKET ADAPTER and SOCKET
adjacent to the side of the LED DRIVER prior to inserting
the RETROFIT TRIM into the CAN.) (FIG. 6A or 6B)
LED HOUSINGS
1. Plug the MALE CONNECTOR of the SOCKET ADAPTER to
the FEMALE CONNECTOR of top of the RETROFIT TRIM.
(FIG. 5)
2. If using TORSION SPRINGS, squeeze both TORSION
SPRING arms together and insert into the TORSION SPRING
SLOTS (or C-CLIPS) of the CAN. (FIG. 6A)
3. Tuck all wires into the CAN and carefully push the RETROFIT
TRIM into CAN. (FIG. 6A or 6B)
________
DIMMING
For a complete list of compatible dimmers, please look up the
item number listed on the cover of this instruction manual at
www.envirolite-LED.com.
____________________________
LIGHT DISTRIBUTION DIAGRAM
____________________________
FIVE-YEAR LIMITED WARRANTY
Envirolite  warrants this product to be free from defects in
material and workmanship for five years from the original date of
purchase by the consumer. This warranty is limited to the counter
replacement at the time of purchase, with the original purchase
receipt. Envirolite  will not be liable for the loss or damage of
any kind, incidental or consequential damages of any kind,
whether based on warranty contract or negligence, and arising in
connection with the sale, use or repair of the product claimed to
be defective. Some states do not allow the exclusion or limitation
of incidental or consequential damages so the above limitation
may not apply to you. This warranty gives you specific legal
rights and you may also have other rights, which vary from state
to state. Misuse, accident, improper installation or maintenance
will also void the warranty.
___________
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and
receiver.
• Install the product onto on a circuit different from that to
which the receiver is connected.
• Consult with the dealer or an experienced radio/TV
technician for help.
CAUTION: Any changes made to the electronics circuit will void
this equipment’s compliance with Part 15 of the FCC Rules and
should not be operated.
_____________________________
Conforms to standard ICES-CAN 005 (B) / NMB-005 (B)
-/+180
150
120
90
60
30
-150
-120
-90
-60
-30
0
70
140
210
280
350