Installation Guide

OPERATION:

 Turn on power at the circuit breaker or fuse box.

 Turn the light switch on to activate the fixture.

CARE AND CLEANING:

NOTE: Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a

dry soft cloth to dust or wipe carefully.

 Use a dry or slightly dampened clean cloth and wipe the surface of the fixture.

 Disconnect power to the fixture by turning off the circuit breaker or by removing the

fuse at the fuse box.

 Use a dry or slightly dampened clean cloth to wipe the interior surface of the fixture.

TROUBLESHOOTING:

FCC NOTICE:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiver antenna.

 Increase the separation between the equipment and receiver.

 Install the product onto on a circuit different from that to which the receiver is

connected.

 Consult with the dealer or an experienced radio/TV technician for help.

 CAUTION: Any changes made to the electronics circuit will void this equipment’s

compliance with Part 15 of the FCC Rules and should not be operated.

Problem

Solution

The light will not turn on.

 Make sure the power supply is on.

 Test or replace the switch.

 Check the wiring.

 Make sure the grey and purple dimming wires

are not touching each other.

The fuse blows or circuit breaker

trips when light is turned on.

 Check the wire connections.