Installation Guide

____________________________
ASSEMBLY AND INSTALLATION
1. Remove the screw (A) near the access plate (B)
located on the back of the fixture. [Fig. 1]
2. Punch out one of the knockouts (C) in the
access plate (B). [Fig. 1]
3. Open the access plate (B) and thread the
supply wires through the knockout (C). Insert
the supply wires into the quick connector (D)
aligning the black supply wire with the black
fixture wire and the white supply wire to the
white fixture wire. [Fig. 2]
4. If the fixture needs to be dimmed, connect it to a
0-10V dimmer. Punch out one of the knockouts
(E) located around the back portion of the fixture
and pull the dimming wires out through that
knockout (E). [Fig. 3]
5. Place the access plate (B) back onto the fixture
and secure it with the screw (A) that was
previously removed. [Fig. 1]
6. Hook the hangers into the oblong holes in the
back of the fixture and through the round holes
on the end of the fixture. [Fig. 4]
________
DIMMING
1. Use a 0-10V dimmer only.
2. Remove the 2 screws on each end of the back
channel cover and remove the cover.
3. Insert the purple dimming wire into the quick
connecter with the purple fixture wire. Insert
the grey dimming wire into the quick
connector with the grey fixture wire. [Fig. 5]
4. Place the channel cover back on and secure it in
place with the two screws that were previously
removed.
2FT LED HIGH BAY, 11500 LUMENS, 5000K,
120-277V, 0-10V DIMMING
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions. Failure to do so may lead
to electrical shock or fire, which may cause injury or death.
________
CAUTION
WARNING – RISK OF FIRE: Turn off the main power at the circuit breaker
before installing the fixture or performing other maintenance in order to
prevent possible shock.
_________
GENERAL
All electrical connections must be in accordance with local, and national
electrical codes.
Prior to installation remove all protective plastic film covering from the fixture.
Tools needed for installation: Phillips screwdriver, wire strippers, and
pliers.
Fig. 1
Fig. 5
Fig. 3
Fig. 4
Fig. 2