Installation Guide

INSTALLATION & ASSEMBLY:
1. Turn off the power at the circuit breaker box.
2. Remove the fixture from the packaging.
3. Pull the light assembly away from the fixture pan.
[Fig. 1]
4. Remove a knockout near the center of the fixture pan.
If the fixture will be connected to a dimmer, remove an
additional knockout from the fixture pan.
5. Align the fixture pan over the outlet box. Mark the
location of the fixture pan holes onto the ceiling. Drill a
hole at each marking on the ceiling. Carefully hammer a
ceiling anchor into each drilled hole. [Fig. 3]
Note: If the fixture does not sufficiently cover the outlet
box, slide in the semi-circular junction box covers on
the back of the fixture until they snap on securely. [Fig.
2]
6. Thread the power supply wires through the knockout
hole. If the fixture will be connected to a dimmer, pull
out the dimming wires from any other knockout hole.
See page 2 for dimming connections. If the fixture will
not be connected to a dimmer, cap off each of the
dimming wires with a wire nut. [Fig. 5]
7. Align the fixture pan with the ceiling anchors and
screw an anchor screw into each ceiling anchor.
[Fig. 3]
8. Insert the black supply wire and white supply wire
into the corresponding openings of the quick
connector. Connect the fixture ground wire and the
supply ground wire together using a wire nut. Wrap
the wire connection with electrical tape for a more
secure connection. Carefully tuck all the wires and wire
connections into the outlet box. [Fig. 4]
9. Align the fixture pan over the outlet box and slide the
fixture pan so that the screws are on the narrow end of
the keyhole slots. Tighten each screw. [Fig. 6]
10. Snap the light assembly back onto the fixture pan.
11. Restore power at the circuit breaker box.
4
Fig. 5
PURPLE FIXTURE WIRE
GREY FIXTURE WIRE
NO DIMMING
Fig. 2
Fig. 6
Fig. 3
Fig. 1
Fig. 4