Instructions / Assembly

INSTALLATION INSTRUCTIONS

Please read carefully and save these instructions. Failure to do so may lead to

electrical shock or fire, which may cause injury or death.

________

CAUTION

WARNING – RISK OF FIRE: Turn off the main power at the circuit breaker before

installing the fixture, changing lamps, or performing other maintenance in order to

prevent possible shock.

_________

GENERAL

All electrical connections must be in accordance with local, and national electrical

codes.

Prior to installation it is important to follow the following guidelines:

A. Use only the type of tube light specified, with wattage not greater than

specified on the wattage label found on the fixture.

B. Remove all protective plastic film covering from the fixture.

___________________________

ASSEMBLY AND INSTALLATION

1. Turn the lock pin (A) and squeeze the channel at the markers shown to remove

the channel cover.

2. Place track assemblies into slots in the end of the channel.

3. Pull the tracks toward the end of the channel to lock into place.

4. With the power off, connect the black supply wire to the black fixture wire.

Connect the white supply wire to the white fixture wire. Connect the ground supply

wire to the green ground screw.

5. Align channel cover and push it down to snap it into place. Note: the arrow on the

label points to the end with the fixture wires.

6. Line up the T8 tube with the end marked “L & N” into the side where the arrow on

the label is pointing. Insert the lamp into the socket and rotate 90° (a quarter turn)

to lock it in place.

8-FT 4-LIGHT T8 LED INDUSTRIAL STRIP

MODEL: EVSS84T8

BLACK FIXTURE WIRE BLACK SUPPLY WIRE

WHITE FIXTURE WIRE WHITE SUPPLY WIRE

GREEN GROUND SCREW SUPPLY GROUND WIRE

PAGE 1
___________________________ ASSEMBLY AND INSTALLATION 1. Turn the lock pin (A) and squeeze the channel at the markers shown to remove the channel cover. 2. Place track assemblies into slots in the end of the channel. 3. Pull the tracks toward the end of the channel to lock into place. 4. With the power off, connect the black supply wire to the black fixture wire. Connect the white supply wire to the white fixture wire. Connect the ground supply wire to the green ground screw.
PAGE 2
______________________ MONTAJE E INSTALACIÓN 1. Gire el pasador de bloqueo (A) y apriete el canal en los marcadores aparece para retirar la cubierta del canal. 2. Coloque conjuntos de pistas en las ranuras al extremo del canal. 3. Tire de las pistas hacia el extremo del canal para fijar en su lugar. 4. Con el potencia apagada, conecte el cable negro de la alimentación al cable negro de la luminaria. Conecte el cable de alimentación blanco al alambre blanco del luminario.