Operation Instructions 1. Reorient or relocate the receiving antenna. 2. Mover the monitor and the receiver further away from each other. 3. Connect the monitor into an outlet on a circuit different from that to which the receiver is connected. 4. Consult your local dealer or an qualified technician. NOTICE: 1. 2. 3. The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Contert Safety Precautions First Setup Quick Installation Front View of the Product Main Menu Adjusting the picture Supported Timing Modes Technical Specification Care and Maintenance Troubleshooting 1 2 2 4 5 5 7 8 9 9
Safety Precautions English This monitor is manufactured and tested on a ground principle that a user’s safety comes first.However,improper use or installation may result danger to the monitor as well as to the user.Carefully go over the following WARNINGS before installation and keep this guide handy. WARNINGS: This monitor should be operated only at the correct power sources indicated on the label on the rear end of the monitor.
First Setup Congratulation for purchasing this monitor of high performance! This monitor comes with the following accessories: 1. 2. 3. 4. 5. LCD Monitor Owner's Manual Power Cord D-Sub Cable Audio Cable Quick Installation 1. Install / Remove the base Place the display onto the base. Align the display with the swivel on the base and plug the display into the base. Hold up the display and then smack the base by hand to remove it. Install Figure 1 2. 3. 4. 5.
. English Windows users: Setting the Timing Mode(Resolution and Refresh Rate) Example: 1440 x 900 @ 60 Hz Resolution Right-click on the Windows desktop > Properties > Settings > “Desktop Area”. Set the resolution. Refresh Rate (vertical frequency) See your graphic card’s user guide for instructions. Deutsch Example: Français Figure 2 1. 2. 3. 4.
Front View of the Product Figure 3 External Control Button 1. Auto Adjust Key/Exit 3. Increase>/Audio 5. LED 2. Decrease button (②and ③ in fig. 3); see section “OSD Menu Functions”). 2. Press the OSD button MENU (④ in fig.
Main Menu English Deutsch Adjusting the picture The descriptions for function control LEDS Main Main Menu Menu Item Icon Brightness/ Contrast Image Adjust Sub Menu Item Description Brightness Controls the picture’s contrast, brightness, black level and auto level. Contrast Automatically selects the optimal settings for Auto image paramenters(image position ,phase, Adjustment etc.) H-Position Controls the picture’s horizontal position. V-Position Controls the picture’s vertical position.
Main Main Menu Menu Item Icon Sub Menu Item 9300K 6500K Color Custom color sRGB OSD CONTROL Controls the OSD menu’s horizontal position V.OSD Position Controls the OSD menu’s vertical position. Language Input select Speaker Volume Information Autoswitch YES RESET This menu lets you select a preset color temperature (9300K, 6500K or sRGB) by pressing the OSD buttons < or >. Changes to the color temperature take immediate effect on screen.
Supported Timing Modes 7 Français Warning : Do not set the graphic card in your computer to exceed these maximum refresh rates.
Technical Specification Input signal Analog Dsub Digital DVI-D with HDCP Audio Display Type 19” LCD Widescreen Monitor Viewable Diagonal size 48.3cm/19” Native Resolution 1440 x 900 Pixels Colors 16.7M colors Pixel Pitch 0.2835 x 0.
Care and Maintenance z Troubleshooting No power z z z Make sure A/C power cord is securely connected to the power adapter and the power supply is firmly connected to the monitor. Plug another electrical device into the power outlet to verify that the outlet is supplying proper voltage. Make sure all signal cables are installed. Power on but no screen image z z Make sure the video cable supplied with the monitor is tightly secured to the video output prot on back of the computer.If not,tightly secure it.
