Instructions / Assembly

ENVIVO BARN DOOR
PASO 1 – INSTALACION DE LA PUERTA DE BARRA CINTA DOBLADA
STEP 2 - ANTI-JUMP BUMPER INSTALLATION
The barn door comes ready to install, with pre-drilled holes for
mounting the bent strap. To install the bent strap, place the bent
strap on the front of the door and install the bolts, washers, and nuts
in the order demonstrated in (Figure 1-1). Tighten and secure the
2-3/8” strap bolts and washers using a socket wrench. It’s important
to use a wrench to hold the nuts in place as you tighten the strap
bolts with the socket wrench. Also, be sure to install the hex nuts
rst and the cap nuts last.
Measure 10” on the top of the door
panel from both ends and mark
lightly with a pencil (Figure 2-1). Place
the anti-jump bumpers on top of the
door so they are centered on the pencil
mark. Rotate the bumpers so that the
offset screw hole is facing the side of the
door that has the bent strap hardware
attached to it (Figure 2-2). Drill 1/8”
pilot hole through the anti-jump bumper’s
screw hole approximately ½” deep and
use a screw driver to install the screw
making sure to not fully tighten (Figure
2-3). Rotate the bumpers, pivoting on
the screw, so that the bumpers overhang
the door face (Figure 2-4). Once the
door is placed on the rail, the bumpers
can be rotated back into position so that
it is centered on the door and centered
directly under the rail. Then fully tighten
the screws.
Figure 2-1 Figure 2-2
Figure 2-3
Figure 1-1
RESIDENTIAL WOOD DOORS
RESIDENTIAL WOOD DOORS
R
ESIDE
N
TIA
L
W
O
O
D
D
O
O
R
S
RESIDENTIAL WOOD DOORS
RESIDENTIAL WOOD DOORS
R
ESIDE
N
TIA
L
W
O
O
D
D
O
O
R
S
10” 10”
Figure 2-4
3
Figure 1-1 Front Door Face
CAP NUT
STRAP BOLT
HEX NUT
WASHER
WASHER
Envivo Barn Door Info & Install (E&S) Guide.indd 3 7/26/19 9:37 AM