Instructions / Assembly

ENVIVO BARN DOOR
8
STEP 8A/8B – DRYWALL & CONCRETE INSTALLATION
Floor Guide
Figure 8-1
To install the oor-mounted guide,
place the door on the sliding rail
by centering the wheels of the bent
straps on the sliding rail. Then open
the door. Place the guide 1-1/2”
from the edge of the door frame
and insert the oor-mounted guide
into the groove at the bottom of the
door. Mark the holes of the guide on
the oor with a pencil (Figure 8-1)
and pre-drill with 1/8” drill bit prior
to screwing the guide into place with
a screw driver (Figure 8-2). The oor
guide anchors should be used with
all types of ooring except hard-
wood. When installing into hard-
wood ooring, use only the screws
provided.
RESIDENTIAL WOOD DOORS
RESIDENTIAL WOOD DOORS
R
ESIDE
N
TIA
L
W
O
O
D
D
O
O
R
S
1-1/2”
Figure 8-1
STEP 9A/9B – DRYWALL & CONCRETE INSTALLATION
Figure 9-1 Closed
To secure the cushioned angle
door stoppers, rst start with the
door in the closed position. Place a
cushioned angle stopper on the
rail so that it meets the bent strap
hardware in the closed position.
Secure the stopper by tightening
the internal screw with the hex key
(Figure 9-1).
Figure 9-1
RESIDENTIAL WOOD DOORS
RESIDENTIAL WOOD DOORS
R
ESIDE
N
TIA
L
W
O
O
D
D
O
O
R
S
Figure 8-2
Envivo Barn Door Info & Install (E&S) Guide.indd 8 7/26/19 9:37 AM