Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Radio antenna Power cable Take out the factory CD player and unplug all cables.
VL AS Radio antenna Power cable Take out the factory CD player and unplug all cables.
— / — Screw location a oC 0 L Use screwdriver to remove the 4 screws on the factory CD player.
AI Radio antenna Power cable Take out the factory CD player and unplug all cables.
Radio antenna Power cable > Take out the factory CD player and unplug all cables.
VfL Al Radio antenna Power cable Take out the factory CD player and unplug all cables.
Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove 2 screws on the top of head unit, which are used to fix the DVD-ROM inside.
. Volkswagen radio harness Eon radio plug 0.96 0” @ Sl Connect CAN Bus decoder to Eon radio harness in advance. Then connect Eon main unit power connector with factory radio power connector by Volkswagen radio harness.
Connect the Eon radio antenna adapter to the factory radio harness. (Connect the red wire of the radio antenna adapter to the blue auto antenna to power the factory antenna if the radio signal is not good enough.
1 Test all features of the head unit(FM, DVD, SD, USB, Bluetooth, reversing, handbrake, headlight, steering whee! control) before going to next step.
. 7 “ Open the glove box, and pull the USB plug from the center console to the glove box through the gap between them.
Release the weatherstrip on A pillar to install GPS antenna, microphone etc. (Note: The A pillar is near the driver seat.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar, and then reinstall A pillar trim.
Place the GPS antenna and microphone as shown. The wires should be led to the head unit through A pillar and the trim behind the steering wheel.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.
