Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Plastic tool = Pry the air conditioning vent panel from edge with the plastic tool, and put it on the center console. (There is no need to disconnect the cable.
Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove the 2 screws on the top of the head unit, which are used to fix the DVD-ROM inside.
Factory radio plug Eon head unit power plug All Connect the head unit to the car radio plug via Eon radio harness. (If your Eon head unit is equipped with CAN Bus, then please connect the CAN Bus to the Eon power cable first.
A CY Test all features of the head unit(FM, DVD, SD, USB, reversing, handbrake, headlight, steering wheel control) before going to next step.
Open the glove box, and pull the USB plug from the center console to the glove box through the gap between them.
—7 FT 7 Release the weatherstrip on A pillar to install GPS antenna, microphone etc.
Place the microphone here. Stick the dash cam on the windshield. Clip the microphone wherever you want and get the best voice reception.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar, and then reinstall A pillar trim.
Microphone = Place the GPS antenna and microphone as shown. The wires /| should be led to the head unit through A pillar and the trim L behind the steering wheel.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.
