Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Take out the trim panel under the AC controller panel.
1 Wy Phillips screwdriver Use Phillips screwdriver to remove the 4 screws on the AC controller panel, and take the panel out.
Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove 2 screws on the top of head unit, which are used to fix the DVD-ROM inside.
Sr oo J actor radio Connect the head unit with the car radio plug via Eon radio harness.
\O Test all features of the head unit(FM, DVD, SD, USB, Bluetooth, reversing, handbrake, headlight, steering wheel control) before going to next step.
Open the glove box, and pull the USB plug from the center console to the glove box through the gap between them.
< i» 7 Release the weatherstrip on A pillar to install GPS antenna, microphone etc. (Note: The A pillar is near the driver seat.
Place the microphone here. Stick the dash cam on the windshield. Clip the microphone wherever you want and get the best voice reception.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar, and then reinstall A pillar trim.
Place the GPS antenna and microphone as shown. The wires should be led to the head unit through A pillar and the trim behind the steering wheel.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.
