Technical data

9
GB
Installation by a qualifi ed electri-
cian
Drill a hole measuring approx. 10 cm in dia-
meter in the cabin wall at the point where the
main power cable is to be inserted. Run the
cable through the hole toward the outside of
the sauna cabin and connect it to the main
power line in a distributor box suitable for
use in moist environments.
his operation must be performed in accor-
dance with the wiring diagram, the circuit
diagram on the control panel and the regu-
lations of the local EVU and the VDE.
Caution! The local site installati-
on must provide for suffi cient
fuse capacity and an emergency power cut-
off switch.
Illust. 8
Power cable
Distributor box
Fresh-air
inlet
suitable for use
in moist environ-
ments
Please remember that the sensor lines are
thin, fl exible tubes that must not be squee-
zed or subjected to pressure.
These lines must never be cut, as this will
destroy the components.
Safety cutoff
The sauna heater is equipped with a tem-
perature limiter for security.
In case of a malfunction this temperature
limiter cuts off all 3 phases by safety re-
asons.
Once the temperature limiter has cut off the
current, he must be reset mechanically.
Attention:
Cut off the sauna heater from the
mains at fi rst.
Loosen the securtiy screw from the wall
holder of the heater and take the heater off
the holder.
Then open the lid of the terminal box. The
temperature limiter is mounted in the left
lower corner (fi g.9).
Press the 3 locking pins of the connecting
plug back to the rear side of the housing until
you feel a switching point.
Close the terminal box again and restore the
sauna heater in the wall holder.
Secure the heater with the security screw.
In case the temperature limiter should cut
off again immediately after taking into ope-
ration, the sauna heater has to be checked
by a specialist.
Temperature limiter for security
3 locking pins behind
connecting plug
Illust. 9