Datasheet


Minimal overall length tolerance (±0.35 mm) for mounting between heat sink and bus bar

Case with extra groove near the base for clamp mounting (recommended ring clamp
B44030A0165B ... A0190B)
This version is available only for capacitors without threaded stud and for diameters
≥ 64.3 mm.
Regarding ripple current and useful life, please refer to column I
AC,R
(B) in the table "Technical
data and ordering codes" and in the useful life curves.
Dimensions and weights for heat sink mounting:
Ter-
minal
Dimensions (mm) with insulating sleeve Min. reach
of screw
mm
Approx.
weight
g
d l ±1 l
1
±0.35 d
2
max. a +0.2/0.4
M5
M5
64.3 +0/0.8
64.3 +0/0.8
80.7
105.7
86.3
111.3
13.2
13.2
28.5
28.5
7.3
7.3
370
440
M6
M6
76.9 +0/0.7
76.9 +0/0.7
105.7
143.2
110.6
148.1
17.7
17.7
31.7
31.7
9.7
9.7
620
840
M6
M6
91.0 +0/2
91.0 +0/2
97.0
144.5
101.4
148.9
17.7
17.7
31.7
31.7
9.7
9.7
1000
1200
Dimensions for other sizes are available upon request.
Ordering codes:
Design Identification in third
block of ordering code
Remark
Low inductance (13 nH) M003 For capacitors with diameter d ≥ 64.3 mm
For heat sink mounting M007 For capacitors with diameter d ≥ 64.3 mm and
without threaded stud
PAPR terminal style M050 Not for low inductance
PAPR terminal style and
heat sink mounting
M057 For capacitors with diameter d ≥ 64.3 mm and
without threaded stud; not for low inductance
B43456, B43458
Extremely compact  85 °C
Page 7 of 22Please read Cautions and warnings and
Important notes at the end of this document.