Datasheet

B43510, 4-pin snap-in terminals, PVC insulation and PET insulation cap on terminal side
Dimensions
(mm)
Approx.
weight (g)
Packing
units (pcs.)
d +1.4 l +2.2/2
35 50 63 60
35 60 76 36
35 70 88 36
35 80 101 36
35 100 126 36
40 40 71 33
40 50 89 33
40 60 107 33
40 70 125 33
40 80 143 33
40 90 161 33
40 100 178 33
45 40 90 28
45 50 113 28
45 60 136 28
45 70 158 28
45 80 181 28
45 90 204 28
45 100 226 28
Standard snap-in terminals:
length (6.3 +1/1.4) mm. Also available with
length of (4.5 1.4) mm. PET insulation cap is
positioned under the insulation sleeve.
All pin holes must be drilled into the PC-board,
since the unconnected pins serve as mountings.
These pins must be soldered to isolated pads or
pads with the same potential as the negative
pole.
B43510, B43520
Compact  85 °C
Page 5 of 23Please read Cautions and warnings and
Important notes at the end of this document.