User manual

Seite 4 von 9
Stand August 2018 Z385-MG
2. Getting started guide GS24S/xx-360 with 9-pole screw terminal block
1. Select operating mode:
Jumper 1: I – speed reference internal (default mode),
E- speed reference external
Jumper 2: I – enable (RF) internal (default mode),
E– enable (RF) external
2. Connect the following digital input, when enable is external
(connect terminal 7 to terminal 9).
3. Connect the following analogue inputs, when speed reference external
Input N set point (terminal 8) voltage 0 to + 10 V or potentiometer (10kOhm):
Between terminal 4 (GND), terminal 7 (+10V) and terminal 8 (taper from
potentiometer).
4. Connect DC motor to terminals 5 and 6.
5. Connect power supply to terminal 3 (GND) and terminal 2 (power supply +)
(approx.. 12-36V DC)
6. Switch on the power supply.
7. LED (power on) lights up on circuit board.
8. The motor turns and the rotation speed can be adjusted with the voltage on
terminal 8 (n speed-reference), when set value is external mode.
You can adjust the rotation speed with the internal potentiometer N,
when set value is internal mode (jumper 1).