User manual

ManualsBrandsEPH ELEKTRONIK ManualsDrive EngineeringGS24S/10/P 1Q Speed Controller With Integral Current Limiter

Seite 1 von 9

Stand August 2018 Z385-MG

Assembly instruction / User manual

Chopper controller for DC motors type GS 24 S - 360

Technical data under reserve technical changes

Please read these instruction before using and please keep safe for future.

You may download further technical advice under www.eph-elektronik.de.

Summary of content (9 pages)

PAGE 1
Assembly instruction / User manual Chopper controller for DC motors type GS 24 S - 360 Technical data under reserve technical changes Please read these instruction before using and please keep safe for future. You may download further technical advice under www.eph-elektronik.de.
PAGE 2
Table of contents 1. Safety Instructions and Safeguarding ................................................................ 3 1.1. Installation note.......................................................................................... 3 1.2. ESD-protection / Hazard note .................................................................... 3 3. Connecting ......................................................................................................... 5 3.1. Connecting diagram...................
PAGE 3
1. Safety Instructions and Safeguarding 1.1. Installation note An external mains adapter is required for the electrical supply of the controller EPH 360. If this mains adapter is itself supplied with a voltage >75V AC or >50V DC the following points have to be considered: The unit should only be installed by qualified specialist personnel. Installation and operation of the unit should comply with the local regulations for electrical installations as well as health and safety regulations.
PAGE 4
2. Getting started guide GS24S/xx-360 with 9-pole screw terminal block 1. Select operating mode: Jumper 1: Jumper 2: I – speed reference internal (default mode), E- speed reference external I – enable (RF) internal (default mode), E– enable (RF) external 2. Connect the following digital input, when enable is external (connect terminal 7 to terminal 9). 3.
PAGE 5
3. Connecting 3.1.
PAGE 6
4. Option change of rotating direction – Type:393 4.1. General information / Operation The additional circuit board 393 provides the facility to change the rotating direction of a permanent magnet motor with a transistor chopper controller type GS24S/xx-360 at low voltage between 12 to 48V DV and a nominal current of max. 6A (10A*). Rotation in the left or right direction can be pre-select at standstill via a 12V to 48V control signal.
PAGE 7
4.2.
PAGE 8
4.3.
PAGE 9
5. Declaration of Conformity The manufacture: EPH elektronik Produktions- und Handelsgesellschaft mbH Rudolf-Diesel-Straße 18 DE-74354 Besigheim-Ottmarsheim Tel.: +49(0)7143/81 52 - 0 herewith declares that the product: Product: Type Transistor D.C.