User manual

ManualsBrandsEPH ELEKTRONIK ManualsDrive EngineeringDLS 24/10/P 1Q Speed Controller With Current Limiter

Seite 1 von 8

Stand: August 2018 Z314-MG

Assembly instruction / User manual

1-Q motor speed control unit digital, type DLS 24/xx-460

Technical data under reserve technical changes

Please read these instruction before using and please keep safe for future.

You may download further technical advice under www.eph-elektronik.de.

Summary of content (8 pages)

PAGE 1
Assembly instruction / User manual 1-Q motor speed control unit digital, type DLS 24/xx-460 Technical data under reserve technical changes Please read these instruction before using and please keep safe for future. You may download further technical advice under www.eph-elektronik.de.
PAGE 2
Table of contents 1. Safety Instructions and Safeguarding ......................................................................... 3 1.1. Installation note................................................................................................... 3 1.2. ESD-Protection / Hazard note............................................................................. 3 2. Getting started DLS24/xx-460 with 6/4-pole spring clamp terminal ............................. 4 3. Technical features .............
PAGE 3
1. Safety Instructions and Safeguarding 1.1. Installation note An external mains adapter is required for the electrical supply of the controller EPH 460. If this mains adapter is itself supplied with a voltage >50V DC or >75V AC the following points have to be considered: The unit should only be installed by qualified specialist personnel. Installation and operation of the unit should comply with the local regulations for electrical installations as well as health and safety regulations.
PAGE 4
2. Getting started DLS24/xx-460 with 6/4-pole screw terminal block 1. Select modes: • put jumper 1 on 1-2 for internal speed reference (potentiometer 1) or on 2-3 for external speed reference. • put jumper 2 on 1-2 for 12V motor or on 2-3 for 24V motor. • put jumper 3 on 1-2 for speed reference max. 5V or on 2-3 for 10V target value input. • put jumper 4 on 1-2 for internal controller enable or 2-3 for external controller enable (terminal 4). 2.
PAGE 5
3. Technical features • • • • • Power supply Ue: 12V DC – 36V DC High frequency f>20 kHz, this results in low-noise operation Electric connection via spring clamp terminals High level of effectiveness by using Power Mosfets Mounting: mounted with screws or on a 35mm mounting rail The dispose of this product has to be done via separate electrical- and electronic equipment disposal. 4.
PAGE 6
5. Connecting 5.1. Control connections Speed reference value: Terminal 1: GND Terminal 2: wiper external potentiometer (10kOhm) Terminal 3: 5V DC Controller enable (RF): Terminal 4: Input 10-36V DC H/active UE2: Terminal 5: Output (12-36V DC, <50mA) e.g.
PAGE 7
5.2.
PAGE 8
6. CE Declaration of Conformity The manufacturer EPH elektronik Produktions- und Handelsgesellschaft mbH Rudolf-Diesel-Straße 18 DE-74354 Besigheim-Ottmarsheim Tel.