User manual

ManualsBrandsEPH ELEKTRONIK ManualsDrive EngineeringDLR 24/10/P 4Q Speed Controller With Integral Current Limiting

Seite 1 von 10

Stand: August 2018 Z319-MG

Assembly instruction / User manual

4-Q motor speed control unit digital, type DLR 24/xx-466

Technical data under reserve technical changes

Please read these instruction before using and please keep safe for future.

You may download further technical advice under www.eph-elektronik.de.

Summary of content (10 pages)

PAGE 1
Assembly instruction / User manual 4-Q motor speed control unit digital, type DLR 24/xx-466 Technical data under reserve technical changes Please read these instruction before using and please keep safe for future. You may download further technical advice under www.eph-elektronik.de.
PAGE 2
Table of contents 1. Safety instructions and Safeguarding.......................................................................... 3 1.1. Installation note................................................................................................... 3 1.2. ESD-Protection / Hazard note............................................................................. 3 2. Getting started DLS24/xx-466 with 19-pole poliger spring clamp terminal .................. 4 3. Technical feature....................
PAGE 3
1. Safety instructions and Safeguarding 1.1 Installation note An external mains adapter is required for the electrical supply of the speed controller EPH 466. If this mains adapter is itself supplied with a voltage >50V DC or >75V AC the following points have to be considered: The unit should only be installed by qualified specialist personnel. Installation and operation of the unit should comply with the local regulations for electrical installations as well as health and safety regulations.
PAGE 4
2. Getting started DLR24/xx-466 with 19-pole spring clamp terminal 1. Select modes: • put jumper 1 on 1-2 for internal speed reference (potentiometer 1) or on 2-3 for external speed reference (for internal reference put jumper 2 on 1-2 for value max. 5V DC) • put jumper 2 on 1-2 for speed reference max. 5V or on 2-3 for max. 10V DC target value input. • put jumper 3 on 1-2 for 12V motor or on 2-3 for 24V motor.
PAGE 5
3. Technical features • • • • • Power supply Ue: 10V DC – 36V DC (with inverse-polarity protection) High frequency f>20 kHz, this results in low-noise operation Electric connection via spring clamp terminals High level of effectiveness by using Power Mosfets Mounting: mounted with screws or on a 35mm mounting rail The dispose of this product has to be done via separate electrical- and electronic equipment disposal. 4.
PAGE 6
5. Connecting 5.1.
PAGE 7
5.
PAGE 8
Stand: August 2018 Seite 8 von 10 Z319-MG
PAGE 9
5.3. Overview DIP switch Different modes are selectable by using the DIP-switch (mode changes work only, when the power supply is turned off and on). Off Controller enable not inverted (terminals 15 and 16 must be connected, for working motor in the wanted direction) DIP 1 ON Controller enable inverted (terminals 15 and 16 must not be connected, for working motor in the wanted direction) DIP 2 Off Speed ref. enable not inverted (terminal 18 must be connected, for a working ref.
PAGE 10
6. CE Declaration of Conformity The manufacturer EPH elektronik Produktions- und Handelsgesellschaft mbH Rudolf-Diesel-Straße 18 DE-74354 Besigheim-Ottmarsheim Tel.