User manual

ManualsBrandsEPH ELEKTRONIK ManualsDrive EngineeringDC speed controller DGS 24/03 M 3 A 24 Vdc

Stand: August 2018 Seite 1 von 6

Z032-MG

Assembly instruction / User manual

Chopper controller for DC-motors, type DGS 24/03-576

Technical data under reserve technical changes

Please read these instruction before using and please keep safe for future.

You may download further technical advice under www.eph-elektronik.de.

Summary of content (6 pages)

PAGE 1
Assembly instruction / User manual Chopper controller for DC-motors, type DGS 24/03-576 Technical data under reserve technical changes Please read these instruction before using and please keep safe for future. You may download further technical advice under www.eph-elektronik.de.
PAGE 2
Table of contents 1. Safety Instructions and Safeguarding ......................................................................... 3 1.1. Installation note................................................................................................... 3 1.2. ESD-Protection / Hazard note............................................................................. 3 2. Getting started DGS24/03-576 with 7/3.pole spring clamp terminal ............................ 3 3. Technical feature................
PAGE 3
1. Safety instruction and safeguarding 1.1. Installation note An external mains adapter is required for the electrical supply of the speed controller EPH 576. If this mains adapter is itself supplied with a voltage >50V DC or >75V AC the following points have to be considered: The unit should only be installed by qualified specialist personnel. Installation and operation of the unit should comply with the local regulations for electrical installations as well as health and safety regulations.
PAGE 4
2. Getting started DGS24/03-576 with 7/3-pole spring clamp terminal 1. 2. 3. 4. 5. 6. 7. 3. Select modes: For external reference value from 0 to 5V DC or a potentiometer 10kOhm put jumper to "5V" (see connecting diagram). For external reference value from 0 to 10V DC put jumper to “10V” (see connecting diagram) Connecting of the control wires see connection diagram, page 5. Connect DC-Motor to terminals X1-3 and X1-4.
PAGE 5
. Connecting 5.1. Control connection • • • • • • • • • • X1 - 1 X1 - 2 X1 - 3 X1 - 4 X1 - 5 X1 - 6 X1 - 7 X2 - 1 X2 - 2 X2 - 3 power supply minus (GND) power supply plus (Ue) motor wire 1 motor wire 2 +5V for digital inputs signal „direction“ „enable“ signal +5V for reference value speed reference value GND for reference value 5.2.
PAGE 6
. CE Declaration of conformity The manufacturer EPH elektronik Produktions- und Handelsgesellschaft mbH Rudolf-Diesel-Straße 18 DE-74354 Besigheim-Ottmarsheim Tel.