Specifications
20 21
OWNER’S GUIDE | FOLDING OWNER’S GUIDE | UNFOLDING
FOLDING
FOLDING
6. Stow the handles so they are not damaged when storing or moving your Total Gym
®
.
Figure 1: Sport
™
- Stow the handles on the
arms as shown below.
Figure 2: GTS
®
- Loop the handle straps
around the opposite LAT bar pull pin as
shown below.
Figure 3: PowerTower
®
- Hook the handles
together behind the back of the tower as
shown below.
7. Grasp the upper rail where indicated (on the label inside each of the upper rails)
and lift it toward the tower. As you raise the rails, place one hand behind the tower
to prevent the tower from leaning back.
Grasp Here
8. Push the glideboard and tower together until the unit stands vertical.
9. Lift the rail fold latch located on the hinge crossbar and hook the rails to the
tower crosspin with the latch.
Rail Fold Latch
WARNING:
Lift only where indicated on the upper rail. Lifting elsewhere may
cause the rails to move up the tower during the folding process. This
will cause the tower to lean backwards excessively. If this happens
accidentally, straighten and lower the rails back to the floor. Then start
over. Or you can squeeze the release handle on top of the tower and
pull the tower forward.
1. Unlatch the rails from the tower.
2. Standing at the side of the unit, with one hand behind the tower and the other
hand on the glideboard, tilt the unit slightly backward and use your foot to push the
rail base away from the tower. As the rails begin to lower, the tower will follow the
upper rails forward and then it will begin to pull away from the rails back to an
upright position.
Hold Glideboard
Push Rail Base
Here with Foot
Hold Tower
3. When the tower begins to pull away from the upper rails, grasp the upper rail
where indicated on the inside of the rail just above the hinge (indicated on both
sides) and continue to unfold the rails and lower them to the floor. As the rails
straighten, guide the glideboard rollers into the groove of the upper rail if needed.
Caution! As the rails get close to the floor, the rails feel heavier. To avoid pinching the
rollers in the hinges, do not drop the rails.
Grasp Here
While Unfolding
Grasp Here
Unfolding
WARNING:
The tower is designed to open automatically by pulling away from the
upper rails as the rails begin to unfold. Do not force or push the tower
away from the rails, as this will cause the tower to fall backward.