Specifications

22 23

OWNER’S GUIDE | UNFOLDING OWNER’S GUIDE | TELESCOPING SQUAT STAND AND FOLDING PLATFORM

UNFOLDING

4. Grasp the upper rails near the tower and raise them to a level between 10 and 14.

Grasp Here

5. Remove the folding foot holder from the squat stand and install it on the

upper rails. (Reference Assembly and Set-up Instructions for complete installation

instructions of folding foot holder).

6. Rotate the squat stand up by pulling the squat fold pull pin on the left lower rail

(while facing tower). Adjust to desired height.

Squat Fold Pin

7. Remove the center cable pulley from the back of the tower and attach it to the

glideboard when needed for pulley exercises.

ADJUSTING THE TELESCOPING SQUAT STAND

1. Lift the release lever on the back of the telescoping squat stand. Adjust the

squat stand to the desired level by aligning it over one of the sets of holes in the

folding platform. Release the lever to lock it in place.

FOLDING THE FOLDING PLATFORM

1. Pull the pin on the left side then fold the squat stand down. Reverse the

process to unfold or rotate it out for use.

2. Inspect the lever and pull up on the squat handle to ensure the squat stand is

locked in on both sides.

Telescoping Squat Stand and Folding Platform

REMOVING THE FOLDING PLATFORM

1. Remove the squat stand from the folding platform posts and set it aside.

2. Pull the squat fold pull pin on the left side as shown and tilt the folding platform

slightly toward the glideboard as shown below.

Squat Fold Pull Pin

3. Pull the pin on the right side of the folding platform and rotate the posts to the left

until the right pin is slightly above the rails.

4. Move the folding platform to the left until the ﬁxed pin on top comes out of the hole

in the lower rail, then lift off the folding platform.

Note: This process may be done with the squat stand still attached to the folding

platform, however it is more difﬁcult and requires familiarization, more strength and

dexterity.