Owner's Manual

10. Note the location of the 75 ohm terminal and the

audio/video input jack on the treadmill. For the

television to operate, an antenna or a CATV

cable must be connected to the 75 ohm terminal

or the included AV Wire (88) must be connected

to the audio/video input jack (see page 13).

11. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key

in a secure place; the hex key is used to adjust the walking belt (see pages 29 and 30). To protect the floor

or carpet from damage, place a mat under the treadmill.

75 Ohm

Terminal

8. Slide the Right Upright Sleeve (96) up against

the console assembly. Attach the Right Upright

Sleeve with two #8 x 3/4" Screws (4).

Attach the Left Upright Sleeve (not shown) to

he console assembly in the same way.

Audio/

Video

Input

9. With the help of a second person, raise the

front of the treadmill and insert the crossbar on

the Base (83) into the cutout in the cardboard

stand as shown. Have the second person

hold the treadmill to prevent it from moving

forward or backward.

Firmly tighten the four 3/8” x 3 3/4” Bolts (72).

With the help of the second person, lower the

treadmill off the cardboard stand.

Cardboard

Stand

Console

Assembly