Owner's Manual

1. Make sure that the power cord is unplugged.

Remove the indicated #8 x 3/4" Screws (4) from

the Pulse Receiver Cover (70) on the back of

the Console (66).

2. Next, hold the receiver so that the antenna is

oriented as shown. Attach the receiver to the

Pulse Receiver Cover (70) with the two included

small screws.

3. Connect the wire on the receiver to the wire ex-

tending from the Console (66). Make sure that

no wires are pinched. Reattach the Pulse

Receiver Cover (70) to the Console with the two

#8 x 3/4" Screws (4). Discard the other wires in-

cluded with the receiver.

If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re-

ceiver included with the chest pulse sensor.

Wires

Antenna

Small Screws

Receiver