Owner's Manual

Tower Pulley Adjustment–

Tools required: 5/16" Allen wrench/hex key, 9/16"

pen end wrench/spanner

. Lift the top weight off the

weight stack and insert the

weight pin into the second

weight and the sixth hole

from the top of the weight

rod.

CABLE GUARDS

Check for alignment periodically to ensure that cable

guards are not rubbing on the cable and that they are

performing their intended duty. If the alignment is not

roper, loosen the bolt slightly, readjust the cable

guard as necessary, and retighten the bolt.

Correct Alignment

Incorrect Alignment

Rubbing

Out of

Alignment

Guards

Cable

Pulley

2. Loosen the locknut attach-

ing the pulley to the brack-

et in the top of the tower.

3. Move the pulley to the appropriate location in the

bracket:

• If more slack is needed in the cable, move the

pulley down.

• If less slack is needed in the cable, move the

pulley up.

4. Make sure that the cable guard is properly ori-

ented (see CABLE GUARDS) and retighten the

locknut attaching the pulley to the bracket.

5. Lift the top weight and remove the weight pin.

Lower the top weight onto the second weight.

6. Readjust as necessary.

Locknut