Owner's Manual

10
MAINTENANCE
For safe and trouble-free operation of your EPIC STRENGTH strength equipment, it is important to perform
preventive maintenance on a regular basis. Make sure that all parts are properly tightened each time the strength
machine is used. Replace any worn parts immediately. The strength machine can be cleaned with a cloth damp-
ened with water and a mild, non-abrasive soap. Do not use solvents.
Note: Instruct all personnel to perform equipment inspection and maintenance requirements. Personnel must
record and report any accident. For any questions or concerns, see HOW TO CONTACT CUSTOMER CARE
on the back cover of this manual.
Use only original EPIC STRENGTH parts for repair or replacement to maintain your machine’s warranty.
FreeMotion Fitness recommends the following procedures:
SCHEDULED MAINTENANCE
DAILY
1. Upholstery—General cleaning:
• Wipe using a cloth dampened with a solution of
warm water and a mild soap.
• If necessary, use a soft bristle brush with the
cleaning solution.
• Always remove the cleaning solution using a
cloth dampened with clean water. Rinse often.
2. Upholstery—Difficult stains:
• Spray the stain with a non-abrasive household
cleaner such as FORMULA 409
®
cleaner,
SIMPLE GREEN
®
, or a similar product.
• Rub the area gently and let it sit for a few min-
utes.
• Rinse thoroughly using a cloth dampened with
clean water.
• Repeat if necessary using a soft bristle brush.
Optional method for difficult stains:
•
Rub the area gently using a cloth dampened
with rubbing alcohol.
• Rinse thoroughly using a cloth dampened with
clean water to remove alcohol residue.
CAUTION: When using any cleaning product, try
it first in an inconspicuous place to ensure there
is no damage to the material. Follow directions
and adhere to safety precautions of the manufac-
turer of each cleaning agent used. FreeMotion
Fitness and its vendors cannot be held liable for
damage or injuries resulting from the use or mis
-
use of cleaning products.
3. Frames:
• Wipe using a cloth dampened with a solution of
warm water and a mild soap.
• Rinse and dry thoroughly.
Important: Do not use abrasive cleaners,
because they may scratch the equipment. Strong
cleansers and abrasives will damage decals. Use
caution around decals. Do not use solvents such
as lacquer thinner, kerosene, gasoline, or similar
liquids.
4. Stainless Steel Covers:
• Wipe using a cloth dampened with a solution of
warm water and a mild soap.
• Rinse and dry thoroughly.
• If desired, or to remove corrosion, use available
commercial stainless steel polishing com-
pounds. Follow manufacturers’ instructions.
WEEKLY
1. Hardware:
• Check all nuts and bolts. Tighten them as
required.
MONTHLY OR AS REQUIRED
1.
Grips:
• Check and replace as needed.
2.
Pivoting Shafts:
•
Check to ensure the retainer rings are in place
on both ends of the shafts.
3.
W
eight Bars:
• Check to ensure that the bolts are tight and the
bars are secure.