User's Manual

FCC
Near-Body Operation
To maintain compliance with FCC RF exposure requirements, maintain a 5mm, separation distance between the user's body and the
EVDO 1X USB Modem, including the antenna, whether extended or retracted.
The highest SAR value for this EVDO 1X USB MODEM is 1.120 W/kg (CDMA Cellular Band) / 0.966 W/kg (EVDO-Rev.0
Cellular Band) / 1.090 W/kg (EVDO-Rev.A Cellular Band) / 0.217 W/kg (CDMA PCS Band) / 0.261 W/kg (EVDO-Rev.0) /
0.242 W/kg (EVDO-Rev.A). The FCC has granted an Equipment Authorization for this EVDO 1X USB MODEM with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model is on file with the
FCC and can be found under the Display Grant section of http://www.fcc.gov /oet / fcc id after searching on FCC ID: R2NSEC-
8089
Additional information on Specific Absorption Rates (SAR)can be found on the Cellular Telecommunications & Internet
Association (CTIA) web-site at http://phonefacts.net.*In the United States and Canada, the SAR limit for mobile phones used by the
public is 1.6watts/kg (W/kg)averaged over one gram of tissue. The standard incorporates a substantial margin of safety to give
additional protection for the public and to account for any agitations in measurements.
In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-
326 adopted an updated safety standard for human exposure to radio frequency (RF) electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international
standards bodies. The design of this phone complies with the FCC guidelines and these international standards.
For more information about RF exposure, please visit the FCC website at www.fcc.gov
WARNING! Read this information before use
Caution
Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ tv technician for help.