User's Manual

SXT-800U User Quick Manual 4/15
Emergency ‘##02’ + [Index]
- You can set upto 3 Emergency numbers which has up to 16 digits.
- After ##02, Following number is a [ index ] from 1 to 3 associated each emergency number.
- After you enter a index, A lockcode prompt sound will be heard immediately.
- At this time, You can enter lock code. ( a default lock code is “0000” which can be change for
your need)
- After you heard confirmation tone for a right lock code, You can set one of Emergency
numbers..
- And then press À to store it in a memory for preserving it from power-on/off cycle.
- If you press ‘#’ instead of À, What you did will be canceled..
Ex) ##021 Î lockcode prompt sound Î lock code Î911 Î À – Sets and store a
emergecny number #1 as 911
Hotline ‘##03’
- In the Hotline Menu, you can set hotline number which will be dialled automatically whenever
you pick up handset.
- Lockcode prompt sound follows a entering a command of “##03”.
- You can enter lock code. ( a default lock code is “0000” which can be change for your need)
- After you heard confirmation tone for a lock code , You can set a Hotline number..
- And then press À to store it in a memory for preserving it on power-on/off cycle.
- If you press ‘#’ instead of À, it will be canceled.
Ex) ##03 Î enter lock code Î 39533447 + À – Sets and store a hotline as 39533447.
Mirroring ( will be used in a factory ) ‘##04’
- In the Mirroring menu, you can backup/restore system configuration values of Terminal.
- Lockcode prompt sound follows a entering a command of “##04”.
- You can enter lock code. ( a default lock code is “0000” which can be change for your need)
- After you heard confirmation tone for a lock code , You can press À for backing up and ‘#’
for restoring a stored values.
- if it is succeeded, a confirmation tone will be heard and after then, a terminal will be reset.
Ex)
##04 Î enter lock code Î À – Performs backing up system values
##04 Î enter lock code Î ‘#’ – Performs restoring system values
.