Use and Care Manual

16782 Von Karman Ave., Suite 15, Irvine, CA 92606 U.S.A.
888.808.3742 | Fax [phone] | [e-mail] | www.epicureanist.com
TM
Step 1: Deciding where the racks will go.
Please allow 3 1/4” between the Left and Right rack supports. If multiple rack
sets are being used side by side, allow at least 8” between rack sets. Please
check your bottle height to verify that this will be acceptable for you.
(See Diagram “A” below)
Step 2: Mounting the Racks
Mounting is done by placing 3 screws in each of the three holes located on
each rack support. If possible place racks over studs in the wall. If this is not
possible you wll need to purchase wall anchors.
(See Diagram “B” below)
Note: When racks are full of bottles they will weigh approximately 100 lbs.
3
1
/
4
”
Diagram “A” Mounting Dimensions Diagram “B” Installation
8” Minimum
needed between
multiple racks
Please check your
bottles to verify
what this dimension
should be.
Wine Rack Instructions
U.S. Patent #7,882,967