User Manual

Pearl-2 User Guide Configure DHCP

Apply when you're done.

The default gateway and DNS Server fields cannot be left blank. If you do not have a default

gateway or a DNS server for your network, enter the static IP address in those fields.

Configure DHCP

If you need to switch Pearl-2 from using static IP address allocation to using dynamic allocation with DHCP,

you can do this three different ways:

l Restore factory settings, which clear all your custom settings. See Perform a factory reset.

l Load a configuration preset file that uses DHCP networking. See Apply a configuration preset using the

Admin panel or Apply a configuration preset using the touch screen.

l Change the network settings manually using either the touch screen or the Admin panel.

To manually select DHCP as the network type using the touch screen:

1. Tap the gear icon to open the System settings screen. If the control icons aren't showing, tap anywhere

on the touch screen.

2. Tap Network. The Network settings page appears. The currently enabled network type (DHCP or

static) is highlighted green.

3. Tap DHCP, and then tap OK to confirm.