User Manual

Pearl-2 User Guide Configure a static IP address

Label Description

by Ethernet at the network layer. It’s best for all nodes in your network to use the

same value. Only change the MTU value if you know that other nodes use a different

value.

The default gateway and DNS Server fields cannot be left blank. If you do not have a default

gateway or a DNS server for your network, enter the static IP address in those fields.

4. Reboot Pearl-2 when prompted. From the Configuration menu, select Maintenance and click Reboot

Now on the Maintenance page.

5. After the system has finished rebooting, use the new IP address to log back in to the Admin panel as

admin and verify that all changes were applied.

To configure a static IP address using the touch screen:

1. Tap the gear icon to open the System settings screen. If the control icons aren't showing, tap anywhere

on the touch screen.

2. Tap Network. The Network settings page opens. The currently enabled network type (DHCP or static)

is highlighted green.

3. Tap Static IP Address. The Static IP Address configuration page opens.

4. Tap a segment of the IP Address (e.g. 192) to select it and use the keypad to enter a new static IP

address. Continue to enter your Network Mask, Default Gateway, and DNS server information. Tap