User Manual

Pearl-2 User Guide Assign audio sources to an input
3. Do one of the following.
a. To make the ports function as a stereo pair, check Stereo pair and click Apply.
b. To make the ports function as separate mono ports, uncheck Stereo pair and click Apply.
When mono is selected, two sets of parameters and two audio VU meters appear on the
configuration page - one for each audio input port on Pearl-2. Parameters that are listed only
once on the page applies to both ports.
Assign audio sources to an input
Some audio input ports share internal audio processing resources in Pearl-2. These shared audio sources
appear in the same configuration menus in the Admin panel and appear under the same audio input label in
the user interfaces.
The audio sources that share resources are:
l XLR-B (left and right ports)
l RCA (left and right ports)
Both the XLR-B (left/right) and RCA (left/right) audio sources appear under the label Analog-B Audio. You can
assign one or both audio sources to Analog-B Audio. Choosing one audio source for the shared input
disables the other audio source. This means that when you select Analog-B Audio as the audio source for a
layout using the custom layout editor, only the audio source you assign to Analog-B Audio is used. Both audio
sources are assigned by default.
To assign the audio source to an input:
115