User Manual
Pearl-2 User Guide Configure AFU to FTP server parameters
l Check Mark file as downloaded to have the color of the file link in the recording list change to
show the files are downloaded. This only applies if the files are not deleted after upload is
complete.
l Check Create a subfolder for each channel to save the downloaded files in to a folder. Use
either the channel or recorder name.
l Check Create a subfolder for device to save the downloaded files into a folder using the serial
number of Pearl-2.
7. Select the protocol transfer type, and then configure the protocol settings:
l Configure AFU to FTP server parameters
l Configure AFU to RSync server parameters
l Configure AFU to CIFS server parameters
l Configure AFU to SCP client parameters
l Configure AFU to SFTP server parameters
l Configure AFU to AWS S3 parameters
l Configure AFU to WebDav server parameters
l AFU or copy to USB
Configure AFU to FTP server parameters
You can automatically upload recordings to an FTP server when you select FTP as the AFU protocol transfer
type using the Admin panel.
The following table describes the parameters to configure for AFU to an FTPserver.
Table 61 FTP Automatic Upload Configuration Parameters
Name Description
Server
address
The IP address (or fully qualified domain name) of the FTP server.
Server port The port used by the target FTP server. Standard port is 21.
Login User name for the FTP server.
Password Password for the FTP user.
Use temp file
Causes files to be named with .part extension on the server during active upload. When
the upload completes, the file is renamed to the appropriate extension (.mov, .mp4 or
.avi).
380