Specifications

Label Name Description
Status LEDs Three LEDs on the front panel indicate the following Lecture Recorder x2
status:
Solid blue LED indicates device is starting up or indicates a recording error
during a recording session.
Solid green LED indicates the device is ready to capture images.
Flashing green LED indicates files are copied to an external USB drive.
Flashing blue LED indicates:
l a video signal test is in progress;
l system tuning, or
l Lecture Recorder x2 is recording received images.
Note: If the periodic disk check function occurs during start up, it may take
up to 20 minutes to power up the device. During this time the blue LED is
flashes (two intermittent flashes) and the green LED flashes. See Storage
Disk Maintenance for more information.
USB port Connect to one of the following devices:
l big red button for recording control
l external HDD
l USB flash drive
l mouse to start and stop recording
l RS-232 serial port for remote control
Note: Using more than one USB device may impact system performance.
S-Video input Connect to an s-Video source or a composite video source using the
adapter (included).
DVI-I input port Connect to one of the following sources:
l DVI input, use the DVI to DVI cable (included)
l VGA input, use the VGA to DVI adapter (included)
l HDMI input, ( for non-copy protected content), use the HDMI to DVI
adapter (included)
Audio In
Connect to an audio input source.
Back Panel
This section describes the back panel connectors and indicators.