User's Manual

Add Horse 1
Step 5
To start monitoring, you will need to create a
horse ID.
Horses entered by your organisation are under
a title bar with your organisation name.
In the example above, a list of other horses
being monitored is shown - click on ADD HORSE
to create a new entry.
Add Horse 2
Only after the horse has been created, sensors
can be connected to the horse.
If many horses need to be added, it can be done
on the desktop “portal”, where data entry is
easier.
Attach Sensor 1
Step 6
check use the alcohol wipe to clean horse tail
check sensor activated by removing tab
check sensor is near the tablet
Open the sensor packet and use the alcohol
wipe to *clean the tail thoroughly*.
Pull the tab out of the sensor, this activates it.
It is best to activate and attach sensors to horse
names *one at a time*.
Make sure antenna is protruding between horse
tail and rear.
6 7
HEADER (CHANGE ON MASTER B)HEADER (CHANGE ON MASTER B)