User guide

29
3.3.9. Settings / Shutdowns
This power switch supports shutdown facilities of 1 server via its Serial RS232 interface.
- To remove an existing Shutdown association, click on "Delete" of the corresponding rule.
- To modify a Shutdown rule, click on "Edit" of the corresponding rule.
This page is used to create, modify and delete a Shutdown Association.
Click on "Add a New Shutdown" on the right side of the page.
A new page appears, allowing you to set all the parameters of the rule.
Activated
This check box must be checked to activate the Shutdown Rule and enables to deactivate temporarily a
rule while keeping all its settings for a later use.
Shutdown Association ID
The Power Switch automatically creates ID codes to clearly identify each rule. The codes used to indentify
Shutdown Rules start with the letters "SDA" followed by a number.
Shutdown Association Name
In this field, enter the name you want to give to the rule. The name can be from 1 to 32 characters long,
and can contain alphanumeric characters.
Do not use quotes or special characters in labels!
Delay after Shutdown before continue
In this field, specify a delay after which the associated power outlet will be switch to off.
Shutdown Device
In this Drop-Down list, choose the device which will be used to trigger the Shutdown action. If the Power
Switch is used as stand-alone unit, this Drop-Down list will only show the Power Switch itself.