User guide

6
2. INSTALLATION
Remark:
Make sure that the ePowerSwitch 1G
R2
is powered off.
Connection instructions
1. Use a shielded
RJ45 network cable to connect your ePowerSwitch 1G
R2
to the network.
2. Use appropriated three-wire power cords (two poles plus ground) to connect your electrical device to
the ePowerSwitch 1G
R2
unit.
3. Plug the power cable into a grounded
socket. The Status LED lights on to confirm that power is on.
4. You can now configure the ePowerSwitch 1G
R2
by following the indications of the chapter
"Configuration of the ePowerSwitch 1G
R2
".